The size of the gear
source:This site Hangzhou ZHPT Gear Co., Ltd. release time:2019-09-02 10:58:21 Pageviews:846The size of the gear
Nowadays, our living environment and working environment are composed of many mechanical and technological products, and these products are composed of many parts. Among them, a very common but very important part is gears. I believe everyone should You are not unfamiliar with gears. Gears support the operation of the machine. If there are no gears in a machine, it will definitely not work. Then we should usually learn more about gears. What we are going to say today isgearThe size of the problem.
The size of the gear is mainly expressed by the modulus and the number of teeth.
Modulus refers to the ratio of the pitch of the pitch to the circumference (π), in millimeters (mm).
The size of the gear is not only expressed by modulus and number of teeth, but also expressed by CP (Circular pitch) and DP (Diametral pitch). CP is the circumferential tooth pitch on the index circle.The unit is the same as the modulus for millimeters. The relationship between M (modulus) and CP is: M (modulus) = CP/π (circumference ratio).
The above is some knowledge about the size of gears. I hope you can learn more about gears after reading this article. We are a professionalGear manufacturers, If you have any questions you want to know, you can directly call our phone to contact us, and we will continue to share little knowledge about gears with you in the future.
- Things to check before gear operation[2020-12-24]
- Three measuring methods for gears[2020-12-10]
- The nature of the gear involute[2020-11-26]
- Ways to reduce gear transmission noise[2020-11-12]
- Reduction of gear rack transmission gap[2020-10-15]
- Gear failure performance[2020-09-10]